Small angle neutron scattering techniques have been applied to investigate the phase behavior of CO2 injected into coal and possible changes in the coal pore structure that may result from this injection. Three coals were selected for this study: the Seelyville coal from the Illinois Basin (R-o=0.53%), Baralaba coal from the Bowen Basin (R-o=0.67%), and Bulli 4 coal from the Sydney Basin (R-o=1.42%). The coals were selected from different depths to represent the range of the underground CO2 conditions(from subcritical to supercritical) which may be realized in the deep subsurface environment. The experiments were conducted in a high pressure cell and CO2 was injected under a range of pressure conditions, including those corresponding to in-situ hydrostatic subsurface conditions for each coal. Our experiments indicate that the porous matrix of all coals remains essentially unchanged after exposure to CO2 at pressures up to 200 bar (1 bar=10(5) Pa). Each coal responds differently to the CO2 exposure and this response appears to be different in pores of various sizes within the same, coal. For the Seelyville coal at reservoir conditions (16 degrees C, 50 bar), CO2 condenses from a gas into liquid, which leads to increased average fluid density in the pores (rho(pore)) with sizes(r) 1x10(5)>= r >= 1x10(4) angstrom (rho(pore)approximate to 0.489 g/cm(3)) as well as in small pores with size between 30 and 300 angstrom (rho(pore)approximate to 0.671 g/cm(3)). These values are by a factor of three to four higher than the density of bulk CO2 (rho(CO2)) under similar thermodynamic conditions (rho(CO2)-0.15 g/cm(3)). At the same time, in the intermediate size pores with r approximate to 1000 angstrom the average fluid density is similar to the density of bulk fluid, which indicates that adsorption does not occur in these pores. At in situ conditions for the Baralaba coal (35 degrees C, 100 bar), the average fluid density Of CO2 in all pores is lower than that of the bulk fluid (rho(pore)/rho(CO2)approximate to 0.6). Neutron scattering from the Bulli 4 coal did not show any significant variation with pressure, a phenomenon which we assign to the extremely small amount of porosity of this coal in the pore size range between 35 and 100,000 angstrom. (C) 2008 Elsevier B.V. All rights reserved.