| 1 - 8 |
Effects of oxygenated fuel blends on carbonaceous particulate composition and particle size distributions from a stationary diesel engine
Zhang ZH, Balasubramanian R |
| 9 - 16 |
Optimization studies on coal-oil agglomeration using Taguchi (L16) experimental design
Kumar S, Chary GHVC, Dastidar MG |
| 17 - 22 |
Production of upgraded bio-oils by biomass catalytic pyrolysis in an auger reactor using low cost materials
Veses A, Aznar M, Lopez JM, Callon MS, Murillo R, Garcia T |
| 23 - 38 |
Correlation and prediction of biodiesel density for extended ranges of temperature and pressure
Prieto NMCT, Ferreira AGM, Portugal ATG, Moreira RJ, Santos JB |
| 39 - 45 |
Rapid and accurate determination of the lignin content of lignocellulosic biomass by solid-state NMR
Fu L, McCallum SA, Miao JJ, Hart C, Tudryn GJ, Zhang FM, Linhardt RJ |
| 46 - 55 |
Kinetic study of steam gasification of two mineralogically different lignite chars: An active site/intermediate model
Tang J, Wu XT, Wang J |
| 56 - 63 |
Acid-catalyzed conversion of C6 sugar monomer/oligomers to levulinic acid in water, tetrahydrofuran and toluene: Importance of the solvent polarity
Hu X, Wang S, Westerhof RJM, Wu LP, Song Y, Dong DH, Li CZ |
| 64 - 73 |
Modelling of heating and evaporation of n-Heptane droplets: Towards a generic model for fuel droplet/particle conversion
Yin CE |
| 74 - 81 |
Supercritical carbon dioxide extraction of petroleum on kieselguhr
Ni HX, Hsu CS, Lee P, Wright J, Chen R, Xu CM, Shi Q |
| 82 - 92 |
Optimization of the feeding ports location in a fluidized bed combustor based on Monte Carlo simulations of fuel particles motion
Garcia-Gutierrez LM, Soria-Verdugo A, Ruiz-Rivas U |
| 93 - 98 |
Enhanced performance of calcium-enriched coal ash for the removal of humic acids from aqueous solution
Zhang Y, Zhang XM, Song YC, Wang JH |
| 99 - 108 |
Use of sewage sludge combustion ash and gasification ash for high-temperature desulphurization of different gas streams
Gil-Lalaguna N, Sanchez JL, Murillo MB, Gea G |
| 109 - 119 |
Experimental study on diesel conventional and low temperature combustion by fueling four isomers of butanol
Zheng ZQ, Li CL, Liu HF, Zhang Y, Zhong XF, Yao MF |
| 120 - 135 |
Projection of world fossil fuels by country
Mohr SH, Wang J, Ellem G, Ward J, Giurco D |
| 136 - 142 |
Characterization of gasoline/ethanol blends by infrared and excess infrared spectroscopy
Corsetti S, Zehentbauer FM, McGloin D, Kiefer J |
| 143 - 153 |
Potential for aerobic and methanogenic oil biodegradation in a water flooded oil field (Dagang oil field)
Cai MM, Jimenez N, Kruger M, Guo H, Jun Y, Straaten N, Richnow HH |
| 154 - 163 |
Effect of Karanja biodiesel blends on particulate emissions from a transportation engine
Dhar A, Agarwal AK |
| 164 - 172 |
Liquid-liquid phase equilibrium measurements and modeling for systems involving {soybean oil plus ethyl esters plus (ethanol plus water)}
Dagostin JLA, Mafra MR, Ramos LP, Corazza ML |
| 173 - 184 |
Exploring methane-hydrate formation and dissociation in geologic materials through laboratory experiments: Kinetic behavior and morphology
Ruffine L |
| 185 - 191 |
Investigation on characteristics of ion current in a methanol direct-injection spark-ignition engine
Gao ZQ, Li BZ, Li CY, Liu B, Liu SH, Wu XM, Huang ZH |
| 192 - 199 |
The prediction of fuel injection quality using a NOx sensor for the on-board diagnosis of heavy-duty diesel engines with SCR systems
Qiu T, Li XC, Lei Y, Liu XH, Zhang CX, Feng X, Xu H |
| 200 - 206 |
Cycle-based optimal NOx emission control of selective catalytic reduction systems with dynamic programming algorithm
Zhang H, Chen Y, Wang JM, Yang SC |
| 207 - 213 |
Study of flow characteristics of biomass and biomass-coal blends
Guo ZG, Chen XL, Xu Y, Liu HF |
| 214 - 221 |
Rheological properties and stability of lignite washery tailing suspensions
Chen DD, Jiang XG, Lv S, Lv GJ, Ma ZY, Yan JH, Yu XH, Liao HY, Zhao H |
| 222 - 225 |
Recycle of algal residue suspension from acid-catalyzed hot-water extraction (AHE) as substrate of oleaginous yeast Cryptococcus sp.
Seo YH, Sung M, Han JI |
| 226 - 235 |
The effect of hydraulic fracture characteristics on production rate in thermal EOR methods
Shakib JT, Akhgarian E, Ghaderi A |
| 236 - 249 |
Numerical investigation of the heterogeneous combustion processes of solid fuels
Alganash B, Paul MC, Watson IA |
| 250 - 257 |
Effects of pre-treatments on the lipid extraction and biodiesel production from municipal WWTP sludge
Olkiewicz M, Fortuny A, Stuber F, Fabregat A, Font J, Bengoa C |
| 258 - 267 |
Novel Janus magnetic micro particle synthesis and its applications as a demulsifier for breaking heavy crude oil and water emulsion
Ali N, Zhang BL, Zhang HP, Li W, Zaman W, Tian L, Zhang QY |
| 268 - 274 |
Identification of basic nitrogen compounds in ethanol-soluble portion from Zhaotong lignite ethanolysis by positive-ion electrospray ionization Fourier transform ion cyclotron resonance mass spectrometry
Li ZK, Zong ZM, Yan HL, Wei ZH, Li Y, Wei XY |
| 275 - 284 |
Prediction of biomass ash fusion behaviour by the use of detailed characterisation methods coupled with thermodynamic analysis
Rizvi T, Xing P, Pourkashanian M, Darvell LI, Jones JM, Nimmo W |
| 285 - 292 |
Effect of H-2/CO ratio and N-2/CO2 dilution rate on laminar burning velocity of syngas investigated by direct measurement and simulation
Wang ZH, Weng WB, He Y, Li ZS, Cen KF |
| 293 - 304 |
Comparing the porosity and surface areas of coal as measured by gas adsorption, mercury intrusion and SAXS techniques
Okolo GN, Everson RC, Neomagus HWJP, Roberts MJ, Sakurovs R |
