| 963 - 969 |
Comparison of solvent performance for CO2 capture from coal-derived flue gas: A pilot scale study
Frimpong RA, Johnson D, Richburg L, Hogston B, Remias JE, Neathery JK, Liu KL |
| 970 - 976 |
Flow-guided sieve-valve tray (FGS-VT) - A novel tray with improved efficiency and hydrodynamics
Li QS, Zhang MX, Tang XF, Li L, Lei ZG |
| 977 - 987 |
Dynamic modeling of CO2 absorption from coal-fired power plants into an aqueous monoethanolamine solution
Posch S, Haider M |
| 988 - 998 |
Empirical correlations and CFD simulations of vertical two-phase gas-liquid (Newtonian and non-Newtonian) slug flow compared against experimental data of void fraction
Ratkovich N, Majumder SK, Bentzen TR |
| 999 - 1008 |
Heuristic shape optimization of gas ducting in process and power plants
Avvari R, Jayanti S |
| 1009 - 1017 |
Reduced IMRs in a mixing tank via agitation improvement
Wang S, Wu J, Bong EY |
| 1018 - 1027 |
Thin layer drying kinetics, characteristics and modeling of plaster of paris
Pillai MG |
| 1028 - 1038 |
The effects of acid leaching on porosity and surface functional groups of cocoa (Theobroma cacao)-shell based activated carbon
Ahmad F, Daud WMAW, Ahmad MA, Radzi R |
| 1039 - 1049 |
A new targeting method for estimation of cogeneration potential and total annualized cost in process industries
Manesh MHK, Abadi SK, Amidpour M, Hamedi MH |
| 1050 - 1054 |
Effect of synthesized silver nanoparticles in promoting methane hydrate formation at 4.7 MPa and 5.7 MPa
Arjang S, Manteghian M, Mohammadi A |
| 1055 - 1062 |
Effective factor on antibacterial characteristics of Mg1-xNixO solid solution
Ohira T, Yamamoto O |
| 1063 - 1070 |
Monitoring of theophylline dehydration in a vacuum contact dryer by near-infrared spectroscopy
Touil A, Peczalski R, Zagrouba F |
| 1071 - 1084 |
Reconstruction in integrating fault spaces for fault identification with kernel independent component analysis
Liu Y, Wang FL, Chang YQ |
| 1085 - 1094 |
Pattern matching of alarm flood sequences by a modified Smith-Waterman algorithm
Cheng Y, Izadi I, Chen TW |
| 1095 - 1105 |
A quality by design approach to process plant cleaning
Martin E, Montague G, Robbins P |
| 1106 - 1110 |
A kinetic modelling study of ethane cracking for optimal ethylene yield
van Goethem MWM, Barendregt S, Grievink J, Verheijen PJT, Dente M, Ranzi E |
| 1111 - 1122 |
Direct syngas to DME as a clean fuel: The beneficial use of ultrasound for the preparation of CuO-ZnO-Al2O3/HZSM-5 nanocatalyst
Khoshbin R, Haghighi M |
| 1123 - 1132 |
Dynamic mathematical modeling of a novel dual-type industrial ethylene oxide (EO) reactor
Bayat M, Dehghani Z, Hamidi M, Rahimpour MR |
| 1133 - 1144 |
Comparison of normal phase operation and phase reversal studies in a pulsed sieve plate extraction column
Lade VG, Rathod VK, Bhattacharyya S, Manohar S, Wattal PK |
| 1145 - 1154 |
Laboratory cake filtration testing using constant rate
Mandi FM, Holdich RG |
| 1155 - 1162 |
Local solidosity of microcrystalline cellulose during dead-end filtration and sedimentation
Mattsson T, Martinez EL, Sedin M, Theliander H |
| 1163 - 1169 |
Prediction of solubilities of solid solutes in carbon dioxide-expanded organic solvents using the predictive Soave-Redlich-Kwong (PSRK) equation of state
Su CS |
