| 2903 - 2913 |
Energy harvesting from flow-induced vibration: a lumped parameter model
Wang JL, Li GP, Zhang M, Zhao GF, Jin ZL, Xu K, Zhang ZE |
| 2914 - 2922 |
A feasibility study of energy recovery of RDF from municipal solid waste
Nam-Chol O, Hyo-Song P, Yong-Chol S, Yong-Hyok R, Yong-Nam K |
| 2923 - 2932 |
An experimental investigation on the application potential of heterogeneous catalyzed Nahar biodiesel and its diesel blends as diesel engine fuels
Dash SK, Lingfa P, Chavan SB |
| 2933 - 2940 |
Co-production of biodiesel and alpha-linolenic acid (omega-3 fatty acid) from microalgae, Desmodesmus sp. MCC34
Nagappan S, Verma SK |
| 2941 - 2947 |
Development of renewable biomass energy by catalytic gasification: Syngas production for environmental management
Fan JF, Wang DP, Kang L |
| 2948 - 2959 |
Experimental study of acrylamide monomer polymer gel for water plugging in low temperature and high salinity reservoir
Zhang Y, Cai HY, Li JG, Cheng R, Wang MJ, Bai X, Liu YF, Sun YP, Dai CL |
| 2960 - 2966 |
Application of MLP-ANN as a novel predictive method for prediction of the higher heating value of biomass in terms of ultimate analysis
Darvishan A, Bakhshi H, Madadkhani M, Mir M, Bemani A |
| 2967 - 2973 |
Assessment of tracing element characteristics of F-type fly and bottom ash mixture
Kumar S, Singh A, Kumar H |
| 2974 - 2985 |
An investigation into surfactant flooding and alkaline-surfactant-polymer flooding for enhancing oil recovery from carbonate reservoirs: Experimental study and simulation
Firozjaii AM, Derakhshan A, Shadizadeh SR |
| 2986 - 2999 |
Accurate estimation of cost function parameters for thermal power plants using a novel optimization approach
Askarzadeh A, Gharibi M |
| 3000 - 3008 |
Performance evaluation of adaptive neuro-fuzzy inference system and response surface methodology in modeling biodiesel synthesis from jatropha-algae oil
Kumar S, Jain S, Kumar H |
| 3009 - 3018 |
CFD modeling of thermal contact resistance between solid contacting surfaces
Wei YS |
| 3019 - 3028 |
Effect of densification variables on density of corn cob briquettes produced using a uniaxial compaction biomass briquetting press
Orisaleye JI, Jekayinfa SO, Adebayo AO, Ahmed NA, Pecenka R |
