| 1 - 9 |
Inverse analysis of wood pyrolysis with long residence times in the temperature range 210-290 degrees C: Selection of multi-step kinetic models based on mass loss residues
Cavagnol S, Sanz E, Nastoll W, Roesle JF, Zymla V, Perre P |
| 10 - 18 |
Non-isothermal decomposition behavior of Fluorel bonded explosives containing attractive cyclic nitramines
Yan QL, Zeman S, Zhang TL, Elbeih A |
| 19 - 25 |
Crystallization kinetics of montmorillonite/poly(vinylidene fluoride) composites and its correlation with the crystalline polymer phase formation
Lopes AC, Ferreira JCC, Costa CM, Lanceros-Mendez S |
| 26 - 37 |
Aggregation and phase separation behavior of an amphiphilic drug promazine hydrochloride under the influence of inorganic salts and ureas
Rub MA, Asiri AM, Azum N, Khan A, Khan AAP, Khan SB, Rahman MM, Kabir-ud-Din |
| 38 - 46 |
Preparation and characterization of a novel epoxy based nanocomposite using tryptophan as an eco-friendly curing agent
Motahari A, Omrani A, Rostami AA, Ehsani M |
| 47 - 54 |
Particle migration in nanofluids considering thermophoresis and its effect on convective heat transfer
Bahiraei M, Hosseinalipour SM |
| 55 - 62 |
Thermal stability and oxidizing properties of mixed alkaline earth-alkali molten carbonates: A focus on the lithium-sodium carbonate eutectic system with magnesium additions
Frangini S, Scaccia S |
| 63 - 72 |
Structural and thermodynamic properties of new pyrazolo[3,4-d]pyridazinones
Frizzo CP, Villetti MA, Tier AZ, Gindri IM, Buriol L, Rosa FA, Claramunt RM, Sanz D, Martins MAP |
| 73 - 78 |
The activation energy and fragility index of the glass transition in Se76Te21Sb3 chalcogenide glass
Soltan AS, Abu-Sehly AA, Joraid AA, Alamri SN |
| 79 - 84 |
Heat capacities of several Co(2)YZ Heusler compounds
Yin M, Nash P, Chen S |
| 85 - 87 |
Solution enthalpies of 1,4-dioxane: Study of solvent effects through quantitative structure-property relationships
Nunes N, Reis M, Moreira L, Elvas-Leitao R, Martins F |
| 88 - 97 |
Kinetic and chemorheological modeling of the vitrification effect of highly reactive poly(urethane-isocyanurate) thermosets
Chiacchiarelli LM, Kenny JM, Torre L |
| 98 - 108 |
Isothermal curing of polymer layered silicate nanocomposites based upon epoxy resin by means of anionic homopolymerisation
Roman F, Calventus Y, Colomer P, Hutchinson JM |
| 109 - 115 |
The behavior of the AV-17(Cr) sorbent in various media
Gutsanu V, Tudorachi N, Lisa G |
| 116 - 120 |
Fabrication and properties of poly(polyethylene glycol octadecyl ether methacrylate)
Meng JY, Tang XF, Zhang ZL, Zhang XX, Shi HF |
| 121 - 132 |
Thermodynamic assessment of Cu-Ni-Ti ternary system assisted with key measurements
Zhang H, He Y, Yang F, Liu HS, Jin ZP |
| 133 - 139 |
Mesomorphous versus traces of crystallinity: The itraconazole example
Atassi F, Behme RJ, Patel PJ |
| 140 - 144 |
Coupled thermal analysis of novel alumina nanofibers with ultrahigh aspect ratio
Aghayan M, Hussainova I, Gasik M, Kutuzov M, Friman M |
| 145 - 150 |
Injection molding of ceramic filled polypropylene: The effect of thermal conductivity and cooling rate on crystallinity
Suplicz A, Szabo F, Kovacs JG |
| 151 - 153 |
Evidence of variation of oxide ion content in structural phase transition of Ba2Fe2O5+delta observed by simultaneous TG-DTA-MS measurements
Fujishiro F, Okuda K, Hashimoto T |
| 154 - 161 |
A comparative study on two explosive acetone peroxides
Egorshev VY, Sinditskii VP, Smirnov SP |
