1973 - 1979 |
Model studies of the curing of resole phenol-formaldehyde resins Part 1. The behaviour of ortho quinone methide in a curing resin Lenghaus K, Qiao GG, Solomon DH |
1981 - 1988 |
Photooxidation of blends of polystyrene and poly(vinyl methyl ether): FTIR and AFM studies Mailhot B, Morlat S, Gardette JL |
1989 - 1999 |
Quantification of the maleic anhydride grafted onto polypropylene by chemical and viscosimetric titrations, and FTIR spectroscopy Sclavons M, Franquinet P, Carlier V, Verfaillie G, Fallais I, Legras R, Laurent M, Thyrion FC |
2001 - 2008 |
Poly(ether sulphone) copolymers with novel reactive chain-ends Chisari V, Mamo A, Recca A, Siracusa V, Carter JT, McGrail PT |
2009 - 2015 |
Synthesis and characterization of thermally stable polymers containing phenazine Gajiwala HM, Zand R |
2017 - 2028 |
Crosslinking of acrylic latex coatings with cycloaliphatic diepoxide Wu S, Soucek MD |
2029 - 2032 |
Synthesis and characterization of PAn/clay nanocomposite with extended chain conformation of polyaniline Wu Q, Xue Z, Qi Z, Wang F |
2033 - 2039 |
PVA containing chito-oligosaccharide side chain Cho YW, Han SS, Ko SW |
2041 - 2046 |
Confined crystallization behavior of PEO in silica networks Jiang S, Yu D, Ji X, An L, Jiang B |
2047 - 2052 |
Preparation and pervaporation performance of poly(3-alkylthiophene) membrane Teng MY, Lee KR, Liaw DJ, Lai JY |
2053 - 2057 |
Radical copolymerization reactivity of methacryloyl-terminated poly(ethylene glycol methylether) with vinylbenzyl-terminated polystyrene macromonomers Ishizu K, Shen XX, Tsubaki KI |
2059 - 2068 |
The mass transport of methanolic ferric chloride hexahydrate solution in poly(methyl methacrylate) and related optical properties Chou KF, Lee S |
2069 - 2079 |
Effects of molecular weight of SEBS triblock copolymer on the morphology, impact strength, and rheological property of syndiotactic polystyrene/ethylene-propylene rubber blends Hong BK, Jo WH |
2081 - 2094 |
Experimental modeling of the cure kinetics of an epoxy-hexaanhydro-4-methylphthalicanhydride (MHHPA) system Boey FYC, Qiang W |
2095 - 2104 |
Phonon dispersion and heat capacity in cross-beta form of poly(O-acetyl, L-serine) Misra NK, Kapoor D, Tandon P, Gupta VD |
2105 - 2111 |
Self-adhesion of poly(4,4 '-oxydiphenylene biphenyltetracarboximide) and its adhesion to substrates Ree M, Park YH, Shin TJ, Nunes TL, Volksen W |
2113 - 2120 |
Charge recombination luminescence from epoxy resins Part. 1. Correlation of luminescence with cure Sewell GJ, Billingham NC, Kozielski KA, George GA |
2121 - 2126 |
Scanning probe microscopy of pine and birch kraft pulp fibres Simola J, Malkavaara P, Alen R, Peltonen J |
2127 - 2132 |
Complex formation between hydroxypropylcellulose and hexadecyltrimethylamonium bromide as studied by light scattering and viscometry Hormnirun P, Sirivat A, Jamieson AM |
2133 - 2139 |
Polypropylene-polyethylene blend morphology controlled by time-temperature-miscibility Shanks RA, Li J, Yu L |
2141 - 2148 |
Solid state C-13 NMR analysis of syndiotactic copolymers of propene with 1-butene De Rosa C, Auriemma F, Capitani D, Caporaso L, Talarico G |
2149 - 2155 |
Simulation of a PEO based solid polyelectrolyte, comparison of the CMM and the Ewald summation method Ennari J, Neelov I, Sundholm F |
2157 - 2168 |
Enzymatic gelation of the natural polymer chitosan Kumar G, Bristow JF, Smith PJ, Payne GF |
2169 - 2182 |
Study of the cold drawing of nylon 6 fiber by in-situ simultaneous small- and wide-angle X-ray scattering techniques Samon JM, Schultz JM, Hsiao BS |
2183 - 2201 |
Constitutive model for the finite deformation stress-strain behavior of poly(ethylene terephthalate) above the glass transition Boyce MC, Socrate S, Llana PG |
2203 - 2212 |
Diffusion of acetonitrile in conformational isomers of an H12MDI polyurethane Elabd YA, Sloan JM, Barbari TA |
2213 - 2218 |
Draw-ratio-dependent morphology of biaxially oriented polypropylene films as determined by atomic force microscopy Nie HY, Walzak MJ, McIntyre NS |
2219 - 2226 |
Polymeric silsesquioxanes: degree-of-intramolecular-condensation measured by mass spectrometry Wallace WE, Guttman CM, Antonucci JM |
2227 - 2230 |
Glass-transition and secondary relaxation in SBR-1502 from dynamic mechanical data Cerveny S, Ghilarducci A, Salva H, Marzocca AJ |
2231 - 2240 |
Mechanical properties of weakly segregated block copolymers 2. The influence of phase behaviour on tensile properties of poly(styrene-b-butylmethacrylate) diblock copolymers Weidisch R, Michler GH, Arnold M |
2241 - 2248 |
Scanning force microscopy of bulk-filled uniaxially oriented poly(ethylene terephthalate) films Beake BD, Ling JSG, Leggett GJ |
2249 - 2263 |
A study of the molecular relaxations in solid starch using dielectric spectroscopy Butler MF, Cameron RE |
2265 - 2269 |
Electrical and mechanical properties of polyaniline fibres produced by a one-step wet spinning process Pomfret SJ, Adams PN, Comfort NP, Monkman AP |
2271 - 2288 |
Changes in the morphology and orientation of bulk spherulitic polypropylene due to plane-strain compression Pluta M, Bartczak Z, Galeski A |
2289 - 2293 |
Pd catalyzed polycarbonate synthesis from bisphenol A and CO: control of polymer chain - end structure Goyal M, Nagahata R, Sugiyama J, Asai M, Ueda M, Takeuchi K |
2295 - 2299 |
Small angle X-ray diffraction study of blends of nylon 6 and a liquid crystal copolyester Campoy I, Gomez MA, Marco C |
2301 - 2304 |
Polyether ketones derived from bis[4-(4-fluorobenzoyl)phenyl]phenylphosphine oxide Fitch JW, Reddy VS, Youngman PW, Wohlfahrt GA, Cassidy PE |
2305 - 2308 |
Thermal properties of poly(hydroxybutyrate-co-hydroxyvalerate) and poly(epsilon-caprolactone) blends Chun YS, Kim WN |
2309 - 2312 |
Soluble conjugated copolymers based on poly(1,4-phenylenevinylene) Wang GJ, Li M, Guo CW, Wu F, Tian WJ, Chen XF, Shen JC |
2313 - 2317 |
Surface crystallography of polybutene-1 by atomic force microscopy Winkel AK, Miles MJ |
2319 - 2323 |
'Ductile' mixed biopolymer gel composites Plucknett KP, Normand V, Pomfret SJ, Ferdinando D |