| 340 - 347 |
A study of integration of LIGA and M-EDM technology on the micro injection molding of super thin plates with micro through holes
Tseng SC, Chen YC, Lin CH, Shew BY, Kuo CL |
| 348 - 353 |
Carbon black filled polyester as electrically conductive master batch for fibers
Jin X, Xiao CF, An SL, Jia GX, Wang YY |
| 354 - 360 |
Tip-clearance effect on mixing performance of twin screw extruders
Ishikawa T, Nagano F, Kajiwara T, Funatsu K |
| 361 - 373 |
Structure development in melt spinning and cold drawing of poly(ethylene-co-octene) copolymer
Shan H, White JL |
| 374 - 378 |
Effect of distributor geometry on crimp contraction of PET side-by-side bicomponent fibers
Oh TH |
| 379 - 385 |
Effect of compatibilizer distribution on thermal and rheological properties of gelatinized starch/biodegradable polyesters blends
Xie F, Yu L, Liu H, Dean K |
| 386 - 392 |
Numerical simulation of the effect of processing parameters on the flow behavior and breakthrough phenomenon in co-injection molding
Ilinca F, Hetu JF |
| 393 - 401 |
Study of shrinkage and warpage in microcellular co-injection molding
Shen C, Kramschuster A, Ermer D, Turng LS |
| 402 - 411 |
Melting temperature characteristics for polyethylenes from crystal size distribution
Feng L, Kamal MR |
| 412 - 420 |
Experimental/numerical analysis of chaotic advection in a three-dimensional cavity flow
Anderson PD, Ternet D, Peters GWM, Meijer HEH |
| 421 - 431 |
A numerical investigation on the cure cycle of composite brake blocks
Shojaei A |
