| 336 - 344 |
An improvement on design of sheet extrusion dies
Yang GJ, Huang XC, Shen CY, Chen JB |
| 345 - 351 |
Organic-inorganic hybrid material synthesis by on line coupling twin screw extruder with a microwave oven
Jiguet S, Bounor-Legare V, Melis F, Michel A |
| 352 - 359 |
Water penetration stability in water assisted injection molded symmetric ribs
Liu SJ, Wu YC, Lai PC |
| 360 - 368 |
A new plasticating model for amorphous and semi-crystalline polymers in single screw extruders
Zitzenbacher G, Langecker GR |
| 369 - 379 |
Simultaneous biaxial stretching of polypropylene resins of varying tacticity - Part II: Film morphology and properties
Capt L, Rettenberger S, Munstedt H, Kamal MR |
| 380 - 387 |
Optimization of a flat die including elongational viscosity effects
Sun Y, Gupta M |
| 388 - 397 |
Experimental study on factors influencing throughput rate and process of polymer-mineral filler mixing in a twin screw extruder
Ishibashi J, Kikutani T |
| 398 - 409 |
3D finite element simulation of processing of generalized newtonian fluids in counter-rotating and tangential TSE and die combination
Malik M, Kalyon DM |
| 410 - 416 |
Simulation of heat transfer in laser transmission welding
Prabhakaran R, Kontopoulou M, Zak G, Bates PJ, Sidiropoulos V |
| 417 - 422 |
Influence of power law and isothermal simplification on the accuracy in single screw extrusion
Potente H, Bornemann M, Heinrich D, Pape J |
| 423 - 431 |
Melt intercalation in montmorillonite/polystyrene nanocomposites
Nassar N, Utracki LA, Kamal MR |
| 432 - 440 |
Experimental investigation of the effect of the bubble cone on the cooling jets used in the blown film manufacturing process
Li S, Gao N, Ewing A |
| 441 - 448 |
Molding of thin sheets using impact micro-injection molding
Nian SC, Yang SY |
| 449 - 452 |
Ultrasonic vibration hot embossing - A novel technique for molding plastic microstructure
Liu SJ, Dung YT |
