| 1 |
Analysis of viscous fluid flow in a pressure-swirl atomizer using large-eddy simulation
Laurila E, Roenby J, Maakala V, Peltonen P, Kahila H, Vuorinen V
International Journal of Multiphase Flow, 113, 371, 2019 |
| 2 |
Flash boiling hollow cone spray from a GDI injector under different conditions
Wang LB, Wang FJ, Fang TG
International Journal of Multiphase Flow, 118, 50, 2019 |
| 3 |
Interaction between a hollow-cone spray and the co-axial swirling stratified flow in a novel spray pyrolysis furnace
Du W, Sun Z, Lu GM, Yu JG
Canadian Journal of Chemical Engineering, 96(5), 1079, 2018 |
| 4 |
Numerical investigation of injector geometry effects on fuel stratification in a GCI engine
Atef N, Badra J, Jaasim M, Im HG, Sarathy SM
Fuel, 214, 580, 2018 |
| 5 |
Air-liquid interactions in a pressure-swirl spray
Jedelsky J, Maly M, del Corral NP, Wigley G, Janackova L, Jicha M
International Journal of Heat and Mass Transfer, 121, 788, 2018 |
| 6 |
ANALYSIS OF HOLLOW-CONE SPRAY INJECTED IN AN UNCONFINED, ISOTHERMAL, COANNULAR SWIRLING JET ENVIRONMENT
Sanadi D, Rajamanickam K, Basu S
Atomization and Sprays, 27(1), 7, 2017 |
| 7 |
EFFECT OF SWIRL CHAMBER LENGTH ON THE ATOMIZATION CHARACTERISTICS OF A PRESSURE-SWIRL NOZZLE
Dafsari RA, Vashahi F, Lee J
Atomization and Sprays, 27(10), 859, 2017 |
| 8 |
Transient needle motion of an outwardly opening GDI injector and its effects on initial spray formation
Komada K, Moon S
Fuel, 181, 964, 2016 |
| 9 |
EXPERIMENTAL INVESTIGATIONS ON A PIEZO-ACTIVATED HOLLOW CONE INJECTOR -PART I: MEASUREMENT OF NEEDLE LIFT AND ITS INFLUENCE ON SPRAY MORPHOLOGY
Schmid A, Schneider B, Boulouchos K, Wigley G
Atomization and Sprays, 24(10), 841, 2014 |
| 10 |
EXPERIMENTAL INVESTIGATIONS ON A PIEZO-ACTIVATED HOLLOW CONE INJECTOR -PART II: THE INFLUENCE OF NEEDLE LIFT ON DROPLET SIZE DISTRIBUTIONS AND VORTEX FORMATION
Schmid A, Schneider B, Boulouchos K, Wigley G
Atomization and Sprays, 24(10), 859, 2014 |
