| 1 |
Experimental and CFD-DEM numerical evaluation of flow and heat transfer characteristics in mixed pulsed fluidized beds
Li HW, Wang L, Wang T, Du CH
Advanced Powder Technology, 31(8), 3144, 2020 |
| 2 |
Determination of the optimal axial-to-radial flow ratio of the wall-mounted swirling ventilation in fully mechanized excavation face
Li YJ, Wang PF, Liu RH, Jiang YD, Han H
Powder Technology, 360, 890, 2020 |
| 3 |
Start-up and performance of partial nitritation process using short-term starvation
Ye LH, Li D, Zhang J, Zeng HP
Bioresource Technology, 276, 190, 2019 |
| 4 |
Numerical study on premixed hydrogen/air combustion characteristics in micro-combustor with slits on both sides of the bluff body
Yan YF, He ZQ, Xu QY, Zhang L, Li LX, Yang ZQ, Ran JY
International Journal of Hydrogen Energy, 44(3), 1998, 2019 |
| 5 |
Effects of air volume ratio parameters on air curtain dust suppression in a rock tunnel's fully-mechanized working face
Wang H, Nie W, Cheng WM, Liu Q, Jin H
Advanced Powder Technology, 29(2), 230, 2018 |
| 6 |
Structure influence on jet pump operating limits
Zhu XL, Wang DM, Xu CH, Zhu YF, Zhou WD, He F
Chemical Engineering Science, 192, 143, 2018 |
| 7 |
Heat transfer performance in a rotating two-inlet cooling wedge-shaped channel with lateral inflow holes
Li Y, Deng HW, Tao Z, Xu GQ, Tian SQ
International Journal of Heat and Mass Transfer, 108, 1418, 2017 |
| 8 |
Numerical study of the effect of relative humidity and stoichiometric flow ratio on PEM (proton exchange membrane) fuel cell performance with various channel lengths: An anode partial flooding modelling
Xing L, Cai Q, Xu CX, Liu CB, Scott K, Yan YS
Energy, 106, 631, 2016 |
| 9 |
Working Pressure Dependence of WO3-x Thin Films Prepared by Reactive Facing Targets Sputtering
Kim MH, Bark CW, Choi HW, Kim KH
Molecular Crystals and Liquid Crystals, 602(1), 185, 2014 |
| 10 |
Influence of oxygen and argon flow on properties of aluminum-doped zinc oxide thin films prepared by magnetron sputtering
Zhu H, Wang HM, Wan WQ, Yu SJ, Feng XW
Thin Solid Films, 566, 32, 2014 |
