| 1 |
Two-dimensional mapping of residual stresses in a thick dissimilar weld using contour method, deep hole drilling, and neutron diffraction
Woo W, An GB, Truman CE, Jiang WC, Hill MR
Journal of Materials Science, 51(23), 10620, 2016 |
| 2 |
Residual stress and crack initiation in laser clad composite layer with Co-based alloy and WC plus NiCr
Lee C, Park H, Yoo J, Lee C, Woo W, Park S
Applied Surface Science, 345, 286, 2015 |
| 3 |
Through-thickness distributions of residual stresses in an 80 mm thick weld using neutron diffraction and contour method
Woo W, An GB, Em VT, De Wald AT, Hill MR
Journal of Materials Science, 50(2), 784, 2015 |
| 4 |
Fatigue Crack-Tip Stress Mapping Using Neutron Diffraction
Choi GC, Lee MH, Huang EW, Woo W, Lee SY
Korean Journal of Materials Research, 25(12), 690, 2015 |
| 5 |
Using short-time creep relaxation effect to decrease the residual stress in the bonded compliant seal of planar solid oxide fuel cell - A finite element simulation
Zhang YC, Jiang WC, Tu ST, Wen JF, Woo W
Journal of Power Sources, 255, 108, 2014 |
| 6 |
Residual stress determination in a thick ferritic steel weld plate using neutron diffraction
Woo W, Em VT, Seong BS, Mikula P, An GB
Journal of Materials Science, 47(14), 5617, 2012 |
| 7 |
Three-dimensional simulation to study the influence of foil thickness on residual stress in the bonded compliant seal design of planar solid oxide fuel cell
Jiang WC, Zhang YC, Woo W, Tu ST
Journal of Power Sources, 209, 65, 2012 |
| 8 |
Effect of Al2O3 film on thermal stress in the bonded compliant seal design of planar solid oxide fuel cell
Jiang W, Zhang YC, Woo W, Tu ST
Journal of Power Sources, 196(24), 10616, 2011 |
| 9 |
Prediction of hardness minimum locations during natural aging in an aluminum alloy 6061-T6 friction stir weld
Woo W, Choo H, Withers PJ, Feng Z
Journal of Materials Science, 44(23), 6302, 2009 |
| 10 |
Feasibility of thermal strain measurements during quasi-steady state using neutron diffraction
Woo W, Feng Z, Wang XL, An K, Bailey WB, David SA, Hubbard CR, Choo H
Materials Science Forum, 524-525, 387, 2006 |
