검색결과 : 10건
| No. | Article |
|---|---|
| 1 |
An investigation into the effect of gas adsorption on safety valve set pressure variations Yu XC, Zhang J, Zhao SL, Yu XH, Liu HL Chemical Engineering Science, 188, 170, 2018 |
| 2 |
Experiments and transient simulation on spring-loaded pressure relief valve under high temperature and high pressure steam conditions Yang L, Wang ZJ, Dempster W, Yu XH, Tu ST Journal of Loss Prevention in The Process Industries, 45, 133, 2017 |
| 3 |
Fatigue failure mechanisms of a pressure relief valve Makaryants GM Journal of Loss Prevention in The Process Industries, 48, 1, 2017 |
| 4 |
Dynamic behaviour of direct spring loaded pressure relief valves connected to inlet piping: IV review and recommendations Hos CJ, Champneys AR, Paul K, McNeely M Journal of Loss Prevention in The Process Industries, 48, 270, 2017 |
| 5 |
Dynamic behaviour of direct spring loaded pressure relief valves: III valves in liquid service Hos CJ, Champneys AR, Paul K, McNeely M Journal of Loss Prevention in The Process Industries, 43, 1, 2016 |
| 6 |
Dynamic behaviour of direct spring loaded pressure relief valves in gas service: II reduced order modelling Hos CJ, Champneys AR, Paul K, McNeely M Journal of Loss Prevention in The Process Industries, 36, 1, 2015 |
| 7 |
Dynamic behavior of direct spring loaded pressure relief valves in gas service: Model development, measurements and instability mechanisms Hos CJ, Champneys AR, Paul K, McNeely M Journal of Loss Prevention in The Process Industries, 31, 70, 2014 |
| 8 |
An experimental study of an LPG tank at low filling level heated by a remote wall Heymes F, Aprin L, Birk AM, Slangen P, Jarry JB, Francois H, Dusserre G Journal of Loss Prevention in The Process Industries, 26(6), 1484, 2013 |
| 9 |
Scale considerations for fire testing of pressure vessels used for dangerous goods transportation Birk AM Journal of Loss Prevention in The Process Industries, 25(3), 623, 2012 |
| 10 |
Fire performance of LNG carriers insulated with polystyrene foam Havens J, Venart J Journal of Hazardous Materials, 158(2-3), 273, 2008 |