| 1 |
Numerical investigation of the effects of different injection parameters on Damkohler number in the natural gas MILD combustion
Zhang ZW, Li XS, Zhang LQ, Luo C, Mao ZH, Xu YQ, Liu J, Liu GC, Zheng CG
Fuel, 237, 60, 2019 |
| 2 |
Investigation of the effects of preheating temperature of biodiesel-diesel fuel blends on spray characteristics and injection pump performances
Anis S, Budiandono GN
Renewable Energy, 140, 274, 2019 |
| 3 |
MILD combustion of natural gas using low preheating temperature air in an industrial furnace
Tu YJ, Su K, Liu H, Wang Z, Xie YH, Zheng CG, Li WJ
Fuel Processing Technology, 156, 72, 2017 |
| 4 |
Effects of low preheating temperature for ZnO seed layer deposited by sol-gel spin coating on the structural properties of hydrothermal ZnO nanorods
Yoon YC, Park KS, Kim SD
Thin Solid Films, 597, 125, 2015 |
| 5 |
Effect of preheating and annealing temperatures on quality characteristics of ZnO thin film prepared by sol-gel method
Wang MR, Wang J, Chen W, Cui Y, Wang LD
Materials Chemistry and Physics, 97(2-3), 219, 2006 |
| 6 |
Effects of operating parameters on the combustion of medical waste in a controlled air incinerator
Jangsawang W, Fungtammasan B, Kerdsuwan S
Energy Conversion and Management, 46(20), 3137, 2005 |
| 7 |
SHS법을 이용한 복합분말(Al 2 O 3 -SiC) 제조시 TiO 2 첨가의 영향
윤기석, 양범석, 이종현, 원창환
Korean Journal of Materials Research, 12(1), 48, 2002 |
| 8 |
The influence of homogenisation cooling rate, billet preheating temperature and die geometry on the T5-properties for three 6XXX alloys extruded under industrial conditions
Bjornbakk EB, Saeter JA, Reiso O, Tundal U
Materials Science Forum, 396-4, 405, 2002 |
