| 1 |
Numerical investigation of particles characteristics on cyclone performance for sustainable environment
Ijaz M, Farhan M, Farooq M, Moeenuddin G, Nawaz S, Soudagar MEM, Saqilo HM, Ali Q
Particulate Science and Technology, 39(4), 495, 2021 |
| 2 |
Energy cost and ef fi ciency analysis of greenhouse heating system enhancement using phase change material: An experimental study
Yan SR, Fazilati MA, Toghraie D, Khalili M, Karimipour A
Renewable Energy, 170, 133, 2021 |
| 3 |
2 kW급 고체산화물연료전지의 고온배기가스 폐열회수를 위한 일체형 Hot BoP의 설계 및 성능 평가
김영배, 김은주, 윤종혁, 송형운
Applied Chemistry for Engineering, 30(1), 62, 2019 |
| 4 |
Experimental study of hydrodynamics leading to estimation of acceleration length in a laboratory riser system using sand and limestone
Popuri AK, Garimella P
Chemical Engineering Communications, 206(4), 444, 2019 |
| 5 |
Research on the three-dimensional wall temperature distribution and low-temperature corrosion of quad-sectional air preheater in larger power plant boilers
Zhang QN, Sun FZ, Chen CX
International Journal of Heat and Mass Transfer, 128, 739, 2019 |
| 6 |
Estimation of the direct leakage of rotary air preheaters based on temperature distribution modeling
Zhang X, Yuan JQ, Tian Z, Wang JC
International Journal of Heat and Mass Transfer, 134, 119, 2019 |
| 7 |
Hydrodynamic and Heat Transfer Studies in Riser System for Waste Heat Recovery using Chalcopyrite
Popuri AK, Garimella P
Korean Chemical Engineering Research, 56(2), 252, 2018 |
| 8 |
CFD simulation of the preheater cyclone of a cement plant and the optimization of its performance using a combination of the design of experiment and multi-gene genetic programming
Kashani E, Mohebbi A, Heidari MG
Powder Technology, 327, 430, 2018 |
| 9 |
Experimental comparison between four CO2-based transcritical Rankine cycle (CTRC) systems for engine waste heat recovery
Shi LF, Shu GQ, Tian H, Huang GD, Chen TY, Li XY, Li DQ
Energy Conversion and Management, 150, 159, 2017 |
| 10 |
Optimization of the geometry of cyclone separators used in clinker burning process: A case study
Wasilewski M, Brar LS
Powder Technology, 313, 293, 2017 |
