화학공학소재연구정보센터
검색결과 : 52건
No. Article
1 Upscaling the fabrication routine of bioreplicated rose petal light harvesting layers for photovoltaic modules
Fritz B, Hunig R, Guttmann M, Schneider M, Reza KMS, Salomon O, Jackson P, Powalla M, Lemmer U, Gomard G
Solar Energy, 201, 666, 2020
2 Structural and microchemical characterization of Cu(In,Ga)Se-2 solar cells with solution-grown CdS, Zn(O,S), and In-x(O,S)(y) buffers
Jin XW, Popescu R, Pasha A, Schneider R, Hariskos D, Witte W, Powalla M, Gerthsen D
Thin Solid Films, 671, 133, 2019
3 Systematic survey of suitable buffer and high resistive window layer materials in CuIn1-xGaxSe2 solar cells by numerical simulations
Bauer A, Sharbati S, Powalla M
Solar Energy Materials and Solar Cells, 165, 119, 2017
4 Indium zinc oxide window layer for high-efficiency Cu(In,Ga)Se-2 solar cells
Menner R, Paetel S, Wischmann W, Powalla M
Thin Solid Films, 634, 160, 2017
5 High-efficiency Cu(In,Ga)Se-2 solar cells
Friedlmeier TM, Jackson P, Bauer A, Hariskos D, Kiowski O, Menner R, Wuerz R, Powalla M
Thin Solid Films, 633, 13, 2017
6 Cu2ZnSn(S,Se)(4) solar cells based on chemical bath deposited precursors
Gao C, Schnabel T, Abzieher T, Krammer C, Powalla M, Kalt H, Hetterich M
Thin Solid Films, 562, 621, 2014
7 High-efficiency Cu(In,Ga)Se-2 cells and modules
Powalla M, Jackson P, Witte W, Hariskos D, Paetel S, Tschamber C, Wischmann W
Solar Energy Materials and Solar Cells, 119, 51, 2013
8 Optoelectronic characterization of co-evaporated and low-cost Cu(In,Ga)Se-2 solar cells, a comparison
Friedlmeier TM, Perez PM, Klugius I, Jackson P, Kiowski O, Ahlswede E, Powalla M
Thin Solid Films, 535, 92, 2013
9 Rapid thermal processing for printed Cu(In,Ga)(S,Se)(2) solar cells: Comparison of precursor materials
Klugius I, Miller R, Quintilla A, Friedlmeier TM, Blazquez-Sanchez D, Ahlswede E, Powalla M
Thin Solid Films, 535, 107, 2013
10 Impact of annealing on Cu(In,Ga)Se-2 solar cells with Zn(O, S)/( Zn, Mg) O buffers
Witte W, Hariskos D, Eicke A, Menner R, Kiowski O, Powalla M
Thin Solid Films, 535, 180, 2013