1 |
Formation mechanism and mechanical properties of titanium-doped NbC reinforced Ni-based composite coatings Sun ST, Fu HG, Ping XL, Guo XY, Lin J, Lei YP, Wu WB, Zhou JX Applied Surface Science, 476, 914, 2019 |
2 |
Thermodynamic analysis of steam gasification of municipal solid waste Xu PC, Hu M, Shao ZR, Cheng Y Energy Sources Part A-recovery Utilization and Environmental Effects, 40(6), 623, 2018 |
3 |
Comparison of the properties of urea-formaldehyde resins by the use of formalin or urea formaldehyde condensates Dorieh A, Mahmoodi N, Mamaghani M, Pizzi A, Zeydi MM Journal of Adhesion Science and Technology, 32(23), 2537, 2018 |
4 |
Micro-Morphological Features of Cured Urea-Formaldehyde Adhesives Detected by Transmission Electron Microscopy Nuryawan A, Singh AP, Park BD, Causin V Journal of Adhesion, 92(2), 121, 2016 |
5 |
Correlation investigation on the visible-light-driven photocatalytic activity and coordination structure of rutile Sn-Fe-TiO2 nanocrystallites for methylene blue degradation Wang YJ, Zhang YJ, Yu FH, Jin CZ, Liu X, Ma JY, Wang Y, Huang YY, Wang JH Catalysis Today, 258, 112, 2015 |
6 |
Numerical simulation of natural gas non-catalytic partial oxidation reformer Xu YT, Dai ZH, Li C, Li XY, Zhou ZJ, Yu GS, Wang FC International Journal of Hydrogen Energy, 39(17), 9149, 2014 |
7 |
The influence of lattice oxygen in titania on selective catalytic reduction in the low temperature region Seo PW, Cho SP, Hong SH, Hong SC Applied Catalysis A: General, 380(1-2), 21, 2010 |
8 |
Candida rugosa lipase immobilized in Triton-X100 microemulsion based organogels (MBGs) for ester synthesis Dave R, Madamwar D Process Biochemistry, 43(1), 70, 2008 |
9 |
A protocol on yields to synthesize commercial imperative bisphenols using HPA and supported HPA: Effective condensation over solid acid catalysts Udayakumar S, Ajaikumar S, Pandurangan A Applied Catalysis A: General, 302(1), 86, 2006 |
10 |
Effects of formaldehyde to urea mole ratio on thermal curing behavior of urea-formaldehyde resin and properties of particleboard Park BD, Kang EC, Park JY Journal of Applied Polymer Science, 101(3), 1787, 2006 |