1 |
Gas side controlled mass transfer in a new packing with stamped horizontal lamellae operating at extremely low liquid loads Kolev N, Kralev B, Kolev D Chemical Engineering and Processing, 63, 44, 2013 |
2 |
Impact of each individual component of the mutated PTSNag on glucose uptake and phosphorylation in Ralstonia eutropha G(+)1 Raberg M, Kaddor C, Kusian B, Stahlhut G, Budinova R, Kolev N, Bowien B, Steinbuchel A Applied Microbiology and Biotechnology, 95(3), 735, 2012 |
3 |
Packing with stamped horizontal lamellae operating at extremely low liquid loads II. Effective surface area Kolev N, Kralevi B, Razkazova-Velkova E Chemical Engineering & Technology, 31(1), 103, 2008 |
4 |
Packing with stamped horizontal lamellae operating at extremely low liquid loads - III. Packing pressure drop Kolev N, Kralev B, Razkazova-Velkova E Chemical Engineering & Technology, 31(4), 588, 2008 |
5 |
Vertical plates with inclined capillary grooves for redistribution of the liquid phase over the cross-section of packed columns - I. Equations for calculating the liquid flow-rates in the capillary grooves Kolev D, Dzhonova-Atanasova D, Kolev N Chemical Engineering and Processing, 47(5), 833, 2008 |
6 |
Packing with stamped horizontal lamellas operating at extremely low liquid loads - 1. Hydrodynamics of a single plate Kolev N, Kralev B Chemical Engineering & Technology, 30(1), 52, 2007 |
7 |
Determination of liquid radial spreading coefficients of some highly effective packings Dzhonova-Atanasova D, Kolev N, Nakov S Chemical Engineering & Technology, 30(2), 202, 2007 |
8 |
Comparison of the effective area of some highly effective packings Nakov S, Kolev N, Ljutzkanov L, Kolev D Chemical Engineering and Processing, 46(12), 1385, 2007 |
9 |
Effective area of a highly efficient random packing Kolev N, Nakov S, Ljutzkanov L, Kolev D Chemical Engineering and Processing, 45(6), 429, 2006 |
10 |
A new principle for creation of packings operating at extremely low liquid superficial velocity Kolev N, Razkazova-Velkova E, Lozanov P Chemical Engineering and Processing, 43(1), 1, 2004 |