1 |
A new approach to model isobaric heat capacity and density of some nitride-based nanofluids using Monte Carlo method Jafari K, Fatemi MH Advanced Powder Technology, 31(7), 3018, 2020 |
2 |
Influence of heat-loss on compressibility-driven flames propagating from the closed end of a long narrow duct Kurdyumov VN, Matalon M Combustion and Flame, 214, 1, 2020 |
3 |
Review of innovative approaches of thermo-mechanical refrigeration systems using low grade heat Sleiti AK, Al-Ammari WA, Al-Khawaja M International Journal of Energy Research, 44(13), 9808, 2020 |
4 |
Measurements by using an automatic pressure control and predictions of isobaric VLE at 1.5 MPa for binary mixtures of methyl acetate, ethyl acetate, 1-propanol and 1-butanol Susial P, Vera DG, Montesdeoca I, Susial R, Stevenson SD, Melian NP Chemical Engineering Research & Design, 152, 242, 2019 |
5 |
Technical review, evaluation and efficiency of energy recovery devices installed in the Canary Islands desalination plants Urrea SA, Reyes FD, Suarez BP, Bencomo JAD Desalination, 450, 54, 2019 |
6 |
Density of biofuel mixtures (Dibutyl ether plus Heptane) at temperatures from (298.15-393.15) K and at pressures up to 140 MPa: Experimental data and PC-SAFT modeling Abala I, Alaoui FEM, Chhiti Y, Eddine AS, Rujas NM, Aguilar F Fluid Phase Equilibria, 491, 35, 2019 |
7 |
Characterization and determination of thermodynamic properties of waste cooking oil biodiesel: Experimental, correlation and modeling density over a wide temperature range up to 393.15 and pressure up to 140 MPa Aitbelale R, Abala I, Alaoui FEM, Eddine AS, Rujas NM, Aguilar F Fluid Phase Equilibria, 497, 87, 2019 |
8 |
Onset of buoyancy driven convection in an inclined porous layer with an isobaric boundary Celli M, Barletta A International Journal of Heat and Mass Transfer, 132, 782, 2019 |
9 |
Influence of the temperature on the equilibrium phase diagram of the ternary system water plus ammonium chloride+2-propanol at 101.3 kPa Gomis A, Garcia-Cano J, Font A, Gomis V Journal of Chemical Thermodynamics, 131, 33, 2019 |
10 |
Experimental density and PC-SAFT modeling of biofuel mixtures (DBE+1-Heptanol) at temperatures from (298.15 to 393.15)K and at pressures up to 140 MPa Abala I, Alaoui FEM, Chhiti Y, Eddine AS, Rujas NM, Aguilar F Journal of Chemical Thermodynamics, 131, 269, 2019 |