| 1 |
Charge carrier interfacial transfer pathways from TiO2 and Au/TiO2 nanorod arrays to electrolyte and the association with photocatalysis
Liu BS, Wang JY, Yang JJ, Zhao XJ
Applied Surface Science, 464, 367, 2019 |
| 2 |
Effect of the turbulent contribution of the interfacial momentum transfer on the bubbles dynamics and void fraction distribution in vertical bubbly jets
Aouadi A, Bellakhal G, Chahed J
International Journal of Multiphase Flow, 114, 82, 2019 |
| 3 |
Highly conversion efficiency of solar water splitting over p-Cu2O/ZnO photocatalyst grown on a metallic substrate
Tawfik WZ, Hassan MA, Johar MA, Ryu SW, Lee JK
Journal of Catalysis, 374, 276, 2019 |
| 4 |
Bubbles' slip velocity reduction in the near wall region of turbulent bubbly pipe flows under different gravity conditions
Chahed J, Bellakhel G, Kanfoudi H
Chemical Engineering Research & Design, 119, 231, 2017 |
| 5 |
A physically based, one-dimensional three-fluid model for direct contact condensation of steam jets in flowing water
Heinze D, Schulenberg T, Behnke L
International Journal of Heat and Mass Transfer, 106, 1041, 2017 |
| 6 |
Interfacial forces used in two-phase flow numerical simulation
Chuang TJ, Hibiki T
International Journal of Heat and Mass Transfer, 113, 741, 2017 |
| 7 |
Interfacial kinetics in a model emulsion polymerisation system using microelectrochemical measurements at expanding droplets (MEMED) and time lapse microscopy
Oseland EE, Rea A, de Heer MI, Fowler JD, Unwin PR
Journal of Colloid and Interface Science, 490, 703, 2017 |
| 8 |
Polymer-inorganic hybrid proton conductive membranes: Effect of the interfacial transfer pathways
Chen PP, Hao L, Wu WJ, Li YF, Wang JT
Electrochimica Acta, 212, 426, 2016 |
| 9 |
Polymer-Ti3C2Tx composite membranes to overcome the trade-off in solvent resistant nanofiltration for alcohol-based system
Wu XL, Hao L, Zhang JK, Zhang X, Wang JT, Liu JD
Journal of Membrane Science, 515, 175, 2016 |
| 10 |
The kinetics of CNT transfer between immiscible blend phases during melt mixing
Goldel A, Kasaliwal GR, Potschke P, Heinrich G
Polymer, 53(2), 411, 2012 |
