화학공학소재연구정보센터
검색결과 : 19건
No. Article
1 Sub-oxide passivation of silicon nanoparticles through rapid mechanical attrition
Odo EA, Britton' DT, Harting M
Powder Technology, 317, 230, 2017
2 Variable temperature performance of a fully screen printed transistor switch
Zambou S, Magunje B, Rhyme S, Walton SD, Idowu MF, Unigbe D, Britton DT, Harting M
Solid-State Electronics, 126, 59, 2016
3 Electrically active, doped monocrystalline silicon nanoparticles produced by hot wire thermal catalytic pyrolysis
Scriba MR, Britton DT, Harting M
Thin Solid Films, 519(14), 4491, 2011
4 Composition and crystallinity of silicon nanoparticles synthesised by hot wire thermal catalytic pyrolysis at different pressures
Scriba MR, Britton DT, Arendse C, van Staden MJ, Harting M
Thin Solid Films, 517(12), 3484, 2009
5 Hot-wire synthesis of Si nanoparticles
Scriba MR, Arendse C, Harting M, Britton DT
Thin Solid Films, 516(5), 844, 2008
6 Local structure reconstruction in hydrogenated amorphous silicon from angular correlation and synchrotron diffraction studies
Britton DT, Minani E, Knoesen D, Schut H, Eijt SWH, Furlan F, Giles C, Harting M
Applied Surface Science, 252(9), 3194, 2006
7 Investigations of intrinsic strain and structural ordering in a-Si : H using synchrotron radiation diffraction
Harting M, Britton DT, Minani E, Ntsoane TP, Topic M, Thovhogi T, Osiele OM, Knoesen D, Harindintwari S, Furlan F, Giles C
Thin Solid Films, 501(1-2), 75, 2006
8 Microstructural defect characterisation of a-Si : H deposited by low temperature HW-CVD on paper substrates
Britton DT, Harting M, Knoesen D, Sigcau Z, Nemalili FP, Ntsoane TP, Sperr P, Egger W, Nippus M
Thin Solid Films, 501(1-2), 79, 2006
9 Microstructure, optical characterization and light induced degradation in a-Si : H deposited at different temperatures
Minani E, Sigcau Z, Adgebite O, Ramukosi FL, Ntsoane TP, Hanindintwari S, Knoesen D, Comrie CM, Britton DT, Harting M
Thin Solid Films, 501(1-2), 84, 2006
10 Vacancy and krypton dynamics in Kr-implanted naturally oxidised aluminium
Harting M, Kanguwe DF, Comrie CM, Nsengiyumva S, Naidoo SR, Derry TE, Britton DT
Materials Science Forum, 445-6, 102, 2004