| 1 |
Effect of cell compression on the performance of a non-hot-pressed MEA for PEMFC
Shrivastava NK, Chatterjee A, Harris TAL
International Journal of Energy Research, 44(1), 370, 2020 |
| 2 |
Enhanced reliability of planar-type solid oxide fuel cell stack incorporating leakage gas induction channels
Kim S, Jang I, Kim C, Lee H, Song T, Yoon H, Paik U
International Journal of Hydrogen Energy, 45(20), 11834, 2020 |
| 3 |
Optimization of contact resistance with better gasketing for a unitized regenerative fuel cell
Bhosale AC, Mahajan MA, Ghosh PC
International Journal of Hydrogen Energy, 44(37), 20953, 2019 |
| 4 |
A STOCHASTIC PONTRYAGIN MAXIMUM PRINCIPLE ON THE SIERPINSKI GASKET
Liu X
SIAM Journal on Control and Optimization, 56(6), 4288, 2018 |
| 5 |
Effects of cure system and, filler on chemical aging behavior of fluoroelastomer in simulated proton exchange membrane fuel cell environment
Xia LC, Wang M, Wu H, Guo SY
International Journal of Hydrogen Energy, 41(4), 2887, 2016 |
| 6 |
Effects of curing systems on the mechanical and chemical ageing resistance properties of gasket compounds based on ethylene-propylene-diene-termonomer rubber in a simulated fuel cell environment
Nah C, Kim SG, Shibulal GS, Yoo YH, Mensah B, Jeong BH, Hong BK, Ahn JH
International Journal of Hydrogen Energy, 40(33), 10627, 2015 |
| 7 |
A Model to Characterize and Predict Fugitive Emissions from Flange Joints
Pansegrau L, Schembecker G, Bramsiepe C
Chemical Engineering & Technology, 37(7), 1205, 2014 |
| 8 |
The contact resistance between gas diffusion layers and bipolar plates as they are assembled in proton exchange membrane fuel cells
Ismail MS, Ingham DB, Ma L, Pourkashanian M
Renewable Energy, 52, 40, 2013 |
| 9 |
Experimental investigation of a passive direct methanol fuel cell with 100 cm(2) active areas
Yousefi S, Ganji DD
Electrochimica Acta, 85, 693, 2012 |
| 10 |
Degradation of the elastomeric gasket material in a simulated and four accelerated proton exchange membrane fuel cell environments
Li G, Tan JZ, Gong JM
Journal of Power Sources, 205, 244, 2012 |
