| 1 |
Gas-assisted powder injection molding: A study about residual wall thickness
Kim D, Ahn S, Lee KH, Nambiar R, Chung SW, Park SJ, German RM
Powder Technology, 239, 389, 2013 |
| 2 |
Gas-assisted powder injection molding: A study on the effect of processing variables on gas penetration
Lee K, de Hoyos M, Ahn S, Nambiar R, Gonzalez MA, Park SJ, German RM
Powder Technology, 200(3), 128, 2010 |
| 3 |
Hierarchical crystalline structure of HDPE molded by gas-assisted injection molding
Zheng GQA, Huang L, Yang W, Yang B, Yang MB, Li Q, Shen CY
Polymer, 48(19), 5486, 2007 |
| 4 |
Modeling of hollow formation and its dynamics in liquid gas assisted injection molding process
Kim DH, Ahn KH
Korea-Australia Rheology Journal, 16(1), 27, 2004 |
| 5 |
Flow Direction When Fan Shaped Geometry is Applied in Gas-Assisted Injection Molding: 1. Flow Model Theory and its Criteria for Predicting Flow Directions
Lim KH
Korean Journal of Chemical Engineering, 21(1), 48, 2004 |
| 6 |
Flow Direction When Fan Shaped Geometry is Applied in Gas-Assisted Injection Molding: 2. Development of Flow Model and its Predictions
Lim KH, Hong SH
Korean Journal of Chemical Engineering, 21(1), 59, 2004 |
| 7 |
PFP성형공정의 기포성장에 관한 모델링
김동학, 안경현
Korean Journal of Rheology, 8(3-4), 207, 1996 |
| 8 |
Secondary-Ion Mass-Spectrometry Without Secondary-Ion Emission - Recombinative Scattering of Hyperthermal Cs+ Ions from a Si(111) Surface-Adsorbed with Water
Yang MC, Lee HW, Kang H
Journal of Chemical Physics, 103(12), 5149, 1995 |
