화학공학소재연구정보센터
검색결과 : 10건
No. Article
1 Incorporation of halloysite nanotubes into forsterite surface layer during plasma electrolytic oxidation of AM50 Mg alloy
Mingo B, Guo Y, Nemcova A, Gholinia A, Mohedano M, Sun M, Matthews A, Yerokhin A
Electrochimica Acta, 299, 772, 2019
2 Analysis of a micro photovoltaic/thermal - PV/T system operation in moderate climate
Bigorajski J, Chwieduk D
Renewable Energy, 137, 127, 2019
3 Thermal comfort assessment of large-scale hospitals in tropical climates: A case study of University Kebangsaan Malaysia Medical Centre (UKMMC)
Azizpour F, Moghimi S, Salleh E, Mat S, Lim CH, Sopian K
Energy and Buildings, 64, 317, 2013
4 Thermal rectification between two thermoelastic solids with a periodic array of rough zones at the interface
Chumak K, Martynyak R
International Journal of Heat and Mass Transfer, 55(21-22), 5603, 2012
5 Thermal environment characterisation of a glass-covered semi-outdoor space subjected to natural climate mitigation
Pagliarini G, Rainieri S
Energy and Buildings, 43(7), 1609, 2011
6 Evaluation of enhanced conduction-corrected modified effective temperature ETFe as the outdoor thermal environment evaluation index
Kurazumi Y, Tsuchikawa T, Matsubara N, Kondo E, Horikoshi T
Energy and Buildings, 43(10), 2926, 2011
7 Conduction-corrected modified effective temperature as the indices of combined and separate effect of environmental factors on sensational temperature
Kurazumi Y, Tsuchikawa T, Kondo E, Horikoshi T, Matsubara N
Energy and Buildings, 42(4), 441, 2010
8 Degradation of high power LEDs at dynamic working conditions
Yang LQ, Hu JZ, Shin MW
Solid-State Electronics, 53(6), 567, 2009
9 On the linear heat transfer correlation of a heated circular cylinder in laminar crossflow using a new representative temperature concept
Wang AB, Travnicek Z
International Journal of Heat and Mass Transfer, 44(24), 4635, 2001
10 On the coupling between mechanical behavior and phase stability in mechanically milled alloy powder
Atzmon M, Xu J, Tian HH
Materials Science Forum, 360-3, 311, 2001