| 1 |
The Influence of Mechanical Recycling on Properties in Injection Molding of Fiber-Reinforced Polypropylene
Evens T, Bex GJ, Yigit M, De Keyzer J, Desplentere F, Van Bael A
International Polymer Processing, 34(4), 398, 2019 |
| 2 |
Prediction of interfacial strength of HDPE overmolded with EPDM
Six W, Bex GJ, Van Bael A, De Keyzer J, Desplentere F
Polymer Engineering and Science, 59(7), 1489, 2019 |
| 3 |
Evaluation of the quality of postconsumer plastics obtained from disassembly-based recycling strategies
Wagner F, Peeters J, De Keyzer J, Duflou J, Dewulf W
Polymer Engineering and Science, 58(4), 485, 2018 |
| 4 |
Water Penetration Behavior in Water-assisted Injection Molding (WAIM): A Study of Product Quality for Different Process and Material Parameters
Sannen S, De Munck M, Van Puyvelde P, De Keyzer J
International Polymer Processing, 27(5), 602, 2012 |
| 5 |
The Influence of Melt and Process Parameters on the Quality and Occurrence of Part Defects in Water-assisted Injection Molded Tubes
Sannen S, De Keyzer J, Van Puyvelde P
International Polymer Processing, 26(5), 551, 2011 |
