| 1 |
New measurement method for vaporization velocity for spreading cryogenic liquid
Kim M, Chung K, Nguyen LD, Choi B, Kim T
Process Safety and Environmental Protection, 133, 97, 2020 |
| 2 |
Feasibility study on a novel heat exchanger network for cryogenic liquid regasification with cooling capacity recovery: Theoretical and experimental assessments
Wang Z, Cai WJ, Han FH, Ji YL, Li WH, Sunden B
Energy, 181, 771, 2019 |
| 3 |
Validation of numerical models for cryogenic-liquid pool spreading and vaporization on solid ground
Nguyen LD, Kim M, Choi B, Chung K
International Journal of Heat and Mass Transfer, 128, 817, 2019 |
| 4 |
Investigation on cryo-wicking performance within metallic weaves under superheated conditions for screen channel liquid acquisition devices (LADs)
Ma Y, Zimnik D, Dreyer M, Li YZ
International Journal of Heat and Mass Transfer, 141, 530, 2019 |
| 5 |
Assessment and validation of evaporation models for cryogenic liquids
Nawaz W, Olewski T, Vechot L
Process Safety and Environmental Protection, 121, 50, 2019 |
| 6 |
Enhancement of the revised Klosek and McKinley method for density calculations of liquefied natural gas (LNG) over the temperature range from (100 to 135) K at pressures up to 10 MPa
Tietz C, Richter M, Kleinrahm R, Span R
Fuel Processing Technology, 165, 19, 2017 |
| 7 |
Density measurements of liquefied natural gas (LNG) over the temperature range from (105 to 135) K at pressures up to 8.9 MPa
Lentner R, Richter M, Kleinrahm R, Span R
Journal of Chemical Thermodynamics, 112, 68, 2017 |
| 8 |
Development of a special single-sinker densimeter for cryogenic liquid mixtures and first results for a liquefied natural gas (LNG)
Richter M, Kleinrahm R, Lentner R, Span R
Journal of Chemical Thermodynamics, 93, 205, 2016 |
| 9 |
A new categorization of release models using a semi-analytic solution
Kim M, Choi B, Kim T
Journal of Loss Prevention in The Process Industries, 35, 80, 2015 |
| 10 |
Modeling of a cryogenic liquid pool boiling by CFD simulation
Liu Y, Olewski T, Vechot LN
Journal of Loss Prevention in The Process Industries, 35, 125, 2015 |
