| 1 |
Method to control an air conditioner by directly measuring the relative humidity of indoor air to improve the comfort and energy efficiency
Lim DK, Ahn BH, Jeong JH
Applied Energy, 215, 290, 2018 |
| 2 |
Comparison of combined cooling, heating and power (CCHP) systems with different cooling modes based on energetic, environmental and economic criteria
Zhang JX, Cao S, Yu LJ, Zhou YD
Energy Conversion and Management, 160, 60, 2018 |
| 3 |
Heat pump control method based on direct measurement of evaporation pressure to improve energy efficiency and indoor air temperature stability at a low cooling load condition
Park YS, Jeong JH, Ahn BH
Applied Energy, 132, 99, 2014 |
| 4 |
Experimental study of gas engine driven air to water heat pump in cooling mode
Elgendy E, Schmidt J
Energy, 35(6), 2461, 2010 |
| 5 |
Comprehensive exergy analysis of a ground-source heat pump system for both building heating and cooling modes
Bi YH, Wang XH, Liu Y, Zhang H, Chen LG
Applied Energy, 86(12), 2560, 2009 |
| 6 |
Performance assessment of a horizontal-coil geothermal heat pump
Yari M, Javani N
International Journal of Energy Research, 31(3), 288, 2007 |
| 7 |
4,4'-Azoxyanisole for temperature calibration of differential scanning calorimeters in the cooling mode - Yes or no?
Cammenga HK, Gehrich K, Sarge SM
Thermochimica Acta, 446(1-2), 36, 2006 |
| 8 |
Temperature, heat and heat flow rate calibration of scanning calorimeters in the cooling mode
Sarge SM, Hohne GWH, Cammenga HK, Eysel W, Gmelin E
Thermochimica Acta, 361(1-2), 1, 2000 |
