| 1 |
Re-entrant auxetic structures fabricated by fused deposition modeling: An experimental study of influence of process parameters under compressive loading
Vyavahare S, Kumar S
Polymer Engineering and Science, 60(12), 3183, 2020 |
| 2 |
A novel environmental contour method for predicting long-term extreme wave conditions
Wang YG
Renewable Energy, 162, 926, 2020 |
| 3 |
Optical analysis of a novel collector design for a solar concentrated thermoelectric generator
Rehman NU, Uzair M, Siddiqui MA
Solar Energy, 167, 116, 2018 |
| 4 |
Experimental and CFD simulations of fluid flow and temperature distribution in a natural circulation driven Passive Moderator Cooling System of an advanced nuclear reactor
Pal E, Kumar M, Nayak AK, Joshi JB
Chemical Engineering Science, 155, 45, 2016 |
| 5 |
Influence of the control system on wind turbine loads during power production in extreme turbulence: Structural reliability
Abdallah I, Natarajan A, Sorensen JD
Renewable Energy, 87, 464, 2016 |
| 6 |
Natural gas fueled compression ignition engine performance and emissions maps with diesel and RME pilot fuels
Imran S, Emberson DR, Diez A, Wen DS, Crookes RJ, Korakianitis T
Applied Energy, 124, 354, 2014 |
| 7 |
Design of a single-tube, endpoint, linear-after-the-exponential-PCR assay for 17 pathogens associated with sepsis
Rice LM, Reis AH, Ronish B, Carver-Brown RK, Czajka JW, Gentile N, Kost G, Wangh LJ
Journal of Applied Microbiology, 114(2), 457, 2013 |
| 8 |
Physical Modeling of Surface Fire Under Nonparallel Wind and Slope Conditions
Balbi JH, Rossi JL, Marcelli T, Chatelon FJ
Combustion Science and Technology, 182(7), 922, 2010 |
| 9 |
Mass transfer and concentration contours between an oblate spheroid buried in granular beds and a flowing fluid
Delgado JMPQ, da Silva MV
Chemical Engineering Research & Design, 87(12A), 1667, 2009 |
| 10 |
Visualization of the flow history contours at the cross-section of a weld-line in an injected molded part
Fathi S, Behravesh AH
Journal of Applied Polymer Science, 109(1), 412, 2008 |
